Skip to main content

Multiband FT8 transceiver

rx-888 teamAbout 2 min

Multiband FT8 transceiver

This project implements a standalone multiband FT8 transceiver with all the FT8 signal processing done by Red Pitaya in the following way:

  • simultaneously record FT8 signals from eight bands
  • use FPGA for all the conversions needed to produce .c2 files (complex 32-bit floating-point data at 4000 samples per second)
  • use on-board CPU to process the .c2 files with the FT8 decoder

With this configuration, it is enough to connect Red Pitaya to an antenna and to a network. After switching Red Pitaya on, it will automatically start operating as a FT8 receiver.

Hardware

The FPGA configuration consists of eight identical digital down-converters (DDC). Their structure is shown in the following diagram:

The DDC output contains complex 32-bit floating-point data at 4000 samples per second.

The projects/sdr_transceiver_ft8 directory contains three Tcl files: block_design.tcl, rx.tcl. The code in these files instantiates, configures and interconnects all the needed IP cores.

Software

The write-c2-files.c program accumulates 236000 samples at 4000 samples per second for each of the eight bands and saves the samples to eight .c2 files.

The recorded .c2 files are processed with the FT8 decoder.

The decode-ft8.sh script launches write-c2-files and ft8d one after another. This script is run every minute by the following cron entry in ft8.cron:

* * * * * cd /dev/shm && /media/mmcblk0p1/apps/sdr_transceiver_ft8/decode-ft8.sh >> decode-ft8.log 2>&1 &

GPS interface

A GPS module can be used for the time synchronization and for the automatic measurement and correction of the frequency deviation.

The measurement and correction of the frequency deviation is disabled by default and should be enabled by uncommenting the following line in ft8.cron:

* * * * * cd /dev/shm && /media/mmcblk0p1/apps/common_tools/update-corr.sh 125 >> update-corr.log 2>&1 &

Getting started

  • Download SD card image zip file (more details about the SD card image can be found at this link).
  • Copy the contents of the SD card image zip file to a micro SD card.
  • Optionally, to start the application automatically at boot time, copy its start.sh file from apps/sdr_transceiver_ft8 to the topmost directory on the SD card.
  • Install the micro SD card in the Red Pitaya board and connect the power.

Configuring FT8 receiver

All the configuration files and scripts can be found in the apps/sdr_transceiver_ft8 directory on the SD card.

To enable uploads, the CALL and GRID variables should be specified in upload-ft8.sh. These variables should be set to the call sign of the receiving station and its 6-character Maidenhead grid locator.

The frequency correction ppm value can be adjusted by editing the corr parameter in write-c2-files.cfg.

The bands list in write-c2-files.cfg contains all the FT8 frequencies. They can be enabled or disabled by uncommenting or by commenting the corresponding lines.

Building from source

The installation of the development machine is described at this link.

The structure of the source code and of the development chain is described at this link.

Setting up the Vitis and Vivado environment:

source /opt/Xilinx/Vitis/2023.1/settings64.sh

Cloning the source code repository:

git clone https://github.com/RaspSDR/red-pitaya-notes
cd red-pitaya-notes

Building sdr_transceiver_ft8.bit:

make NAME=sdr_transceiver_ft8 bit

Building SD card image zip file:

source helpers/build-all.sh